Categories

System malfunctions and false alarms can be exasperating, and more importantly, might prevent your security system from working how it should. Fortunately, most troubles, from false alarms to dead batteries, are simple to correct. Check out our recommendations for troubleshooting your home alarm system in Manchester. We’ll help keep your household shielded and your system running the way it should.

Test Your Home Security System In Manchester

One effective way to troubleshoot your home’s security is to test it yourself! Modern systems let you place them in test mode to keep you from prompting an emergency response. After switching to test mode, follow these steps:

• Arm your system as you normally would when you exit your home.
• Open a window or door protected by a contact sensor, or try to trigger another sensor. Close the window or door so it doesn’t trigger the alarm as you turn the system back on.
• Permit the alarm to sound for 60 seconds to ensure communications with the security provider and to create an entry in the alarm activity log.
• Proceed to test sensors as needed
• Check the system activity log to verify that everything’s working.

Rest assured, monitoring agents can see that your alarm system is being tested. Be sure to turn test mode off when done. It’s smart to test monthly or whenever you make changes to your home’s phone or internet provider.

Inspect The Position And State Of Motion Sensors

Although an integral part of your alarm system, motion sensors are well known for false alarms. Do your part to prevent them with a few basic troubleshooting steps.

• Do a physical check. Is there anything that could move within the sensor’s detection range, like a curtain caught in a breeze?
• Is the sensor covered in dust? Dirt, cobwebs, and debris can result in malfunctions. Check to confirm the face is clean.
• Does the motion detector offer pet immunity you can enable? Some models can be set to disregard pets up to 100 pounds.
• When was the battery last replaced? A low battery might impact performance or cause false alarms.
• Is a heat source affecting the sensor? Excess heat from a fireplace, direct sun, or something else can set off an alarm.

Keep Batteries On Hand And Pay Attention To Low Battery Warnings

One helpful aspect of the latest home security systems is that they’ll notify you when batteries are dying. If your system uses a app or control panel, you’ll often discover alerts there. Depending on your alarm, you could notice an intermittent beep when batteries are running out. 

Contact sensors, motion detectors, smoke detectors, and other wireless components have batteries that will have to be replaced every so often. It’s best to keep batteries on hand and establish a replacement schedule. Many systems also come with a backup battery for the primary control panel. This battery helps keep your system functioning if you lose power and should recharge once the electricity is working again. If it fails to recharge, you will need to replace it.

Troubleshooting Is Simple With ADT Home Security In Manchester 

As the foremost name in home security, ADT builds systems that offer superior functionality and convenience. Getting into test mode is simple through the ADT+ app or MyADT.com, and you’ll always be sent alerts when a battery is running low. Get in touch with Secure24 Alarm Systems, an authorized ADT dealer, to find out more and design a system ideal for your Manchester home. Place a call to (603) 932-7598 or fill out our form today!